Causes:

1、内墙腻子粉抛光时间掌握不好，表面已经干燥后再进行抛光处理就会脱粉。

1. If the powder is not removed, the polishing time will be mastered.

2、腻子粉批刮比较薄，在夏天高温条件下，水分挥发过快造成胶黏体系破坏，因而容易脱粉。

2. The putty powder is thin. Under the high temperature condition in summer, the water volatilizes too fast, resulting in the damage of the adhesive system, so it is easy to remove the powder.

3、产品超过保质期，粘结力度大幅度下降。

3. When the product exceeds the shelf life, the bonding strength decreases significantly.

4、产品储存不当，吸潮后粘结力大幅度下降。

4. If the product is stored improperly, the adhesion decreases significantly after moisture absorption.

5、基层吸水率高，导致腻子干燥速度很快，没有充足的水分进行固化。

5. The base course has high water absorption, resulting in rapid drying of putty and insufficient moisture for curing.

处理方法：

Treatment method:

1、内墙腻子面层抛光时要掌握适宜的抛光时间，抛光的较佳时期就是待腻子表面水印消失后，立即进行抛光。实践证明，饰面1~2m2就应该进行压平或抛光处理。

1. Appropriate polishing time shall be mastered when polishing the putty surface of the inner wall. The better period of polishing is to polish immediately after the watermark on the putty surface disappears. Practice has proved that the finish 1 ~ 2M2 should be flattened or polished.

2、外墙腻子表面干燥后，要进行适度打磨，并进行充分的淋水保养，一般保养分为两次或两次以上进行，如果有必要，请用透明封闭底漆兑水（1：5）作为二道淋水液，效果会更好。

2. After the surface of the exterior wall putty is dry, it shall be properly polished and fully watered. Generally, the maintenance is divided into two or more times. If necessary, please use the transparent sealing primer mixed with water (1:5) as the second layer of water spraying solution, and the effect will be better.

3、产品一定要在保质期内使用，如果超过保质期，需要进行试刮，经检验合格后，再行施工。

3. The product must be used within the warranty period. If it exceeds the warranty period, it needs to be scraped. After passing the inspection, the construction can be carried out.

4、产品一定要注意防水处理，应存在在阴凉干燥处，并且保证包封完好。

4. The product must pay attention to waterproof treatment. It should be stored in a cool and dry place and ensure that the package is intact.

5、夏天或高温强风气候条件下，在施刮腻子前较好先用清水润湿墙面，墙面表面无明水后即可施刮腻子。龟裂、开裂、暗痕。

5. In summer or under high temperature and strong wind climate conditions, it is better to wet the wall with clean water before applying putty. Putty can be applied after there is no open water on the wall surface. Cracks, cracks and dark marks.

以上就是为大家介绍的有关济南腻子粉的详细介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务

The above is the detailed introduction of Jinan putty powder. I hope it will help you If you have any questions, please contact us We will provide service for you with our attitude