目前，抹面砂浆的应用仍相当普遍，但因施工作业面大、有障碍或多种原因，需中途间歇，会出现施工缝。下面济南抹面砂浆厂家来讲讲墙体抹灰留反槎的方法。

At present, the application of plastering mortar is still quite common. However, due to the large construction surface, obstacles or various reasons, the construction joints may occur if it needs to be interrupted halfway. Next, Jinan plastering mortar manufacturer will talk about the method of retaining reverse tenon in wall plastering.

1、无论内外墙底层抹灰或面层抹灰时，均应将需要留槎部位的墙面抹平槎麻或赶光压实，检查垂直度、平整度无误后，可将2m直尺水平或垂直方向压在欲留槎的部位，然后用铁抹子沿直尺下沿或一侧将多余的砂浆切掉;切除砂浆时，铁抹子尖应略向上或向尺身下挠斜，将斜槎切成60度左右，形成反槎。

1. When plastering the bottom layer or the surface layer of the internal and external walls, the wall surface where the tenon needs to be reserved shall be leveled or polished and compacted. After checking the verticality and flatness, press a 2m ruler horizontally or vertically on the part where the tenon is to be reserved, and then use an iron trowel to cut off the excess mortar along the lower edge or one side of the ruler; When cutting the mortar, the tip of the iron trowel shall be slightly upward or downward, and the oblique tenon shall be cut into about 60 degrees to form a reverse tenon.

2、当外墙有门窗或其他洞口时，抹灰留槎应尽量留在洞口上沿或下沿。

2. When there are doors and windows or other openings in the exterior wall, the plastering tenon shall be left at the upper or lower edge of the opening as far as possible.

为了保持洞口之间窗间墙外抹灰完整，在搭外脚手架时，应将脚手板的铁排木插入洞口上沿或下沿下降4皮砖的墙孔内。这样可给抹灰工留出运抹子空间，为施工缝留在佳位置创造条件。

In order to maintain the integrity of the external plastering between the windows between the openings, when erecting the external scaffold, the iron batten of the scaffold board should be inserted into the wall hole with 4 bricks falling from the upper or lower edge of the opening. This will leave space for the plasterer to transport the trowel and create conditions for the construction joint to stay in a good position.

3、室内墙体抹灰留反槎的几个部位：

3. Several parts of the interior wall plastering with reverse tenons:

1)每上下两步脚手架交接处应留反槎。

1) A reverse tenon shall be reserved at the junction of each two steps of scaffold.

2)电表箱、闸箱、消防箱等需要镶入墙体内的设施(备)不能及时供货时，在洞口四周100mm处留反槎。

2) If the facilities (spare parts) that need to be embedded in the wall, such as electric meter box, gate box and fire box, cannot be supplied in time, a reverse tenon shall be left at 100mm around the hole.

3)外脚手架穿墙的铁排木或卸载的钢丝绳凸出内墙面且影响抹灰时，需在管端或钢丝绳两侧100mm范围内留反槎。

3) When the iron rafts of the outer scaffold passing through the wall or the unloaded steel wire rope protrudes from the inner wall and affects the plastering, the reverse tenon shall be reserved within 100 mm of the pipe end or both sides of the steel wire rope.

4)门口、哑巴口(无门框)、暖气槽两侧未抹1:2水泥砂浆护角时，应在洞、槽边缘以外100mm外留反槎。

4) When 1:2 cement mortar corner protection is not applied to the door, dumb mouth (without door frame) and both sides of the heating slot, a reverse tenon shall be left 100 mm outside the edge of the hole and slot.

5)距踢脚板高度上方50~100mm外留反槎。

5) A reverse tenon shall be reserved 50~100mm above the height of the skirting board.

6)在采暖或给水穿墙横管四周50~100mm外留反槎。

6) A reverse tenon shall be reserved outside 50~100mm around the horizontal pipe for heating or water supply through the wall.

7)厨厕间屋顶穿楼板立管未封堵预留孔而提前抹灰时，在孔四周50~100mm外留反槎。

7) When the vertical pipe of the kitchen and toilet room roof through the floor is plastered in advance without blocking the reserved hole, a reverse tenon shall be left 50~100mm outside the hole.

墙体抹灰留反槎的方法就讲解到这里了，您可以作为相关参考使用，当然要做好预防工作，以防止出现问题，更多事项就来我们网站咨询了解吧！

This is how to leave the reverse tenon in the wall plastering. You can use it as a reference. Of course, you should do a good job in prevention to prevent problems. More matters will come to our website Ask about it!