1、基层应坚实、干净、大致平整、无明水，基层强度应大于或接近腻子的强度。

1. The base layer should be solid, clean, roughly flat, and free of open water. The strength of the base layer should be greater than or close to the strength of the putty.

2、吸水性强的基层应先用清水润湿或喷刷胶水进行封底处理后再刮腻子(稠度以适合施工为宜)。3、新抹灰的水泥墙应在养护期后再刮腻子。

2. The base layer with strong water absorption should be moistened with clean water or sprayed with adhesive for sealing treatment before scraping putty (the viscosity should be suitable for construction). 3. Newly plastered cement walls should be putty applied after the curing period.

4、按腻子粉:水=1:0.5的比例搅拌均匀，静置10~20分钟再次搅拌均匀即可使用。

4. Mix evenly in a ratio of 1:0.5 putty powder to water, let it stand for 10-20 minutes, and then mix evenly again before use.

5、用钢刮板或抹刀按常规批刮，刮涂次数不可过多，通常批刮两次，第二次涂层在前涂层干透情况下方可施工。6、批刮厚度0.8~1.5mm，用量1~1.5kg/m,一般两遍成活。

5. Use a steel scraper or spatula to scrape in regular batches, and the number of scrapes should not be too many. Usually, scrape twice. The second coating can only be applied after the previous coating is completely dry. 6. The thickness of the batch scraping is 0.8-1.5mm, and the dosage is 1-1.5kg/m. Generally, it is successful after two passes.

7、腻子干后，用320#或240#砂纸进行打磨，尽快涂刷涂料或粘贴墙纸。

7. After the putty is dry, polish it with 320 # or 240 # sandpaper and apply paint or wallpaper as soon as possible.

8、用量:在基层平整的情况下，每公斤腻子粉大约可批0.8—1.2平方米(二批)的平整墙面。

8. Dosage: With a flat base, approximately 0.8-1.2 square meters (two batches) of flat wall can be applied per kilogram of putty powder.

更多的关于济南腻子粉问题或者详细的内容，请进入我们公司的网站：网站中会有很多的内容仅供参考http://www.jnadx.co

For more information or detailed information about Jinan putty powder, please visit our company's website: There will be a lot of content on the website for reference only http://www.jnadx.co